No products in the cart.
40.00€ inc. VAT
Connects 130mm (5 inch) Flexi Flue Liner to 130mm (5 inch) black flue / Vitreous Enamel / 1mm Stainless / Single Wall flue at the bottom of the chimney stack.
Made from 316 grade stainless steel, 1mm THICK, it has integral drain hole to let the condensates flow back into the flue.
INSTALLATION – CHECK LIST
1.Make sure the liner will go down the chimney (this can be done by pulling down a small section of the diameter liner you will be using)
2.Sweep your chimney.
3.Check you pot is in good condition, if you are NOT using a suspended cowl then remove the pot from the stack.
Flue Liner should always be fitted from the top.
Make sure the arrows are pointing upwards (gas flow).
Secure a piece of string (at least the same length as the Flue Liner to the Nose Cone (order separately).
Now attach the Nose Cone onto the end of the Flue Liner, again making sure the arrows on the Flue Liner are pointing away from the Nose Cone in a upward direction so when the liner is installed the arrows will be pointing to the top of the chimney
Pull the liner down the chimney using the string and at the same time have someone at the top of the chimney feeding the Flue Liner down, once the Flue Liner is fitted remove the Nose Cone.
It is recommended that chimneys serving solid fuel appliances be swept and maintained as frequently as necessary but at least once a year.
3" (80mm), 5" (130mm), 6" (150mm)
Wall support with hole
Tee 45° with drain plug
1000mm pipe B/F
500mm pipe B/F
Double-wall chimney 250mm
9m flexi flue kit
Tee 90° with drain plug
Tee 90°/black with drain plug
Double-wall chimney 500mm
Username or email address *
Lost your password?
Email address *